Gotham Elevations Performance Decorative Pendant PDPF, Ca User Manual

Browse online or download User Manual for Lighting Gotham Elevations Performance Decorative Pendant PDPF, Ca. Gotham Elevations Performance Decorative Pendant PDPF, Candéo and Ice User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
IMPORTANT SAFETY INFORMATION
For Your Protection, Read Carefully
1. Electric current can cause painful shock
or serious injury unless handled prop-
erly. For your safety, always remember
the following:
Turn off the power supply.
Ground the fixture to avoid potential
electrical shocks.
Do not handle an energized fixture or
energize any fixture with wet hands,
when standing on a wet or damp sur-
face, or in water.
Double check all electrical connections
to be sure they are tight and correct.
2. Specific safety information concerning
lamps:
Match wattage of fixture and lamp ex-
actly.
Do not remove or insert lamp when power
is on.
Do not scratch glass or subject lamp to
undue pressure as either may cause
lamp breakage.
Protect operating lamp from sources
of moisture.
Upon receipt, thoroughly inspect for any
freight damage which should be brought to
the attention of the delivery carrier. Compare
the catalog description listed on the packing
slip with the label on the carton to ensure you
have received the correct merchandise.
INSTALLATION INSTRUCTIONS
Elevations
®
Performance Decorative Pendant
PDPF, Cand
éo
®
and Ice
®
Part No. CJ52008
©2005 Gotham Rev. B 11/07
Elevations
®
- Part I
Direct Mount (PDPF, Candéo and Ice)
I. Ground Prep
1. Temporarily remove top cap and any round decorative piece to expose
support bracket.
2. Removing socket assembly from box, attach socket cup to reflector per trim
instruction.
3. Route wires from reflector/socket assembly through bottom of housing and
plug into ballast assembly. Attach the ballast assembly to top of housing with
the attached screws.
4. Route the (3) ballast source wires and housing ground through the center
hole on the exposed support bracket.
5. Route conductors through top cap, replace the top cap, leaving screws
protruding 1/2 in. through keyholes (See Figure 1A).
6. Separate j-box pan from canopy by loosening the (3) side screws. Twist apart
to separate. VERIFY THAT THE ROUND DECORATIVE ELEMENT (IF RE-
QUIRED) IS ON PRIOR TO CONTINUING!
7. Route socket conductors from fixture through canopy piece hole and place
canopy over extended screws on fixture top (See Figure 1B).
8. Adjust canopy piece and fixture cap until both screw heads are fully captured
on both parts. Tighten both screws in position. SCREWS MUST BE COM-
PLETELY FORWARD IN KEYHOLES FOR FIXTURE TO BE CENTERED! Adjust if
necessary.
II. Ceiling Installation
8. Hang mounting pan by routing j-box wires through back of pan, and using
either 3.5 or 4.5 inch key holes, secure to j-box (See Figure 1C).
9. Hook the safety chain to the canopy's support tab to suspend the entire
assembly. Make all required electrical connections using wire-nuts.
WARNING! Possible falling hazard and risk of serious injury. Gather both
cord and socket leads into tie strap strain relief so that a minimum of two
inches of cord conductors with socket conductors are pulled inside tie strap.
Pull tie strap tight enough to strain relieve all connections. Trim excess strap
material (See Figure 1D).
TRAHCGNITOOHSELBUORT
nimelborpehtetacol,noitidnocdoognimeesyehtfI.eludomni-emarfropmalehtotegamadelbis
ivynarofkcehC
.snoitcaevitcerrocdnasesuacelbissopfotsilgniwollofeht
motpmySesuaCelbissoPnoitcAevitcerroC
OTSLIAFPMAL
THGIL
dezigrenetonerutxifehtgnideeftiucriC·
noitcennocelud
omrotiucricnirorregniriW·
pmalytluaF·
tuptuotsallabroeniL·
tsallabytluaF·
wolooterutarepmettneibmA·
.dezig
renesitiucrictahterusneotesufrorekaerbtiucrickcehC·
erasnoitcennoctahterusneotxobecilpserutxifenimaxE·
.tcerroc
ylbareferp,pmalrehtonaetutitsbusdnapmalytluafehtevomeR·
lanigiroehtecalper,sthgilpmalehtfI.thgilotnwonksitahteno
.enowenahtiw
.egatlovtiucricnepokcehC.erutxiftaegatlovenilkcehC·
.ytiunitnoctiucrickc
ehC·
.snoitidnoclatnemnorivnegnitsixetsniagagnitartsallabkcehC·
TUOSEOGPMAL
GNITHGILRETFA
pmalytluaF· naht
rehtarmotpmyssihttibihxelliwpmalayllanoisaccO·
.pmalwenaetutitsbuS.thgilotgniliafylpmis
NOSELCYCPMAL
FFO
DNA
erutxifotesolcootsinoitalusnI·
hgihootegattawpmaL·
wolegatlovtuptuotsallaB·
)"3tsaelta(eludomdnuoramorfnoitalusnievomeR·
.gnisuohnideificepsegattawpmalllatsnI·
.egatlovtiucricnepokcehC.erutxifehttaegatlov
enilkcehC·
Figure 1A
®
Figure 1B
!
SAVE THESE INSTRUCTIONS
Page view 0
1 2

Summary of Contents

Page 1 - SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INFORMATIONFor Your Protection, Read Carefully1. Electric current can cause painful shockor serious injury unless handled prop-erly.

Page 2 - Rev B. 11/07

Figure 1C10. Position the complete assembly to align the "V" notch on thecanopy with the "V" notch inside the mounting pan. Tuck i

Comments to this Manuals

No comments