DescriptionThe Gotham Incito downlighting family utilizes DMX512 protocol via a DMX converter module (DMXR option (HPEPP module), see figure 1) over C
DETAILED FUNCTION TABLEFunction 1 - Enable Button Override (aka Button Mode, Focus)4 blinks = button override disabled 5 blinks = button override enab
DETAILED FUNCTION TABLE, Cont’dFunction 4 = Configure behavior on loss of DMX Signal1 blink = Hold last level forever 2 blinks = Fade to off over 1 se
IMPORTANT SAFETY INFORMATIONFor Your Protection, Read Carefully • To reduce the risk of death, personal injury or property damage from fire, elect
IMPORTANT SAFETY INFORMATIONFor Your Protection, Read Carefully Never connect components under load. Do not moun
Protocols SupportedThe DMXR module supports the current DMX standard ANSI E1.11 DMX512-A and is backwards compatible to USITT DMX512 (1990). Also supp
IncitoIncitoIncitoFigure 2 - DMX512 Universe ExampleHPEPP, see fig. 2Daisy Chain CAT5Incito Incito IncitoSplitterIncito IncitoIncito IncitoIncito Inci
DMX512/RDM Pinout Configuration (ANSI E1.11)*CAT5, CAT5E, CAT6 cable must be spliced into XLR cable from console or utilize 5 pin XLR to RJ45 adaptor.
0-10V LED DriverThermal ProtectorHPEPP Module (DMXR Option)Incito 6” Downlight Wiring DiagramTo LEDsHPEPP Module (DMXR Option)CJ520003 Rev. E©2012 Acu
Incito 6” Cylinder Wiring Diagram*On the cylinder with DMXR option, the HPEPP module ships separately and must be installed to the junction box in cei
Configuring HPEPP Interface Module (DMXR Option)The following functions can be configured using either RDM (recommended) or the on-board pushbutton in
Comments to this Manuals