Gotham SQW trim User Manual download pdf

Upon receipt, thoroughly inspect for

any freight damage which should be

brought to the attention of the delivery

carrier. Compare the catalog

description listed on the packing slip

with the label on the carton to ensure

that you have received the correct

merchandise.

IMPORTANT SAFETY INFORMATION

For Your Protection, Read Carefully

Warning: Risk of fire. Do not install

insulation within 3 inches of fixture

sides or wiring compartment, nor above

fixture in such a manner as to entrap

heat.

SAVE THESE INSTRUCTIONS

NEW INSTALLATION FOR SQ TRIM

1. Remove trim from upper reflector by gripping flange and pulling out.

2. Using a screwdriver, push (4) clips in and move towards center of upper reflector (See Figure 1).

3. Thread socket cup through hole in upper reflector (See Figure 2).

4. Attach upper reflector to housing by inserting retention screw into keyhole slot, do not tighten (See

Figure 3). For wallwash reflectors, make sure to orient wallwash kicker toward wall to be illuminated

(See Figure 6).

5. Reposition spring clips to engage both the slots in the upper reflector and mounting frame (See

Figure 4).

6. Tighten screw until spring clips are tight against slot in mounting frame. DO NOT OVER TIGHTEN

(See Figure 4).

7. Attach socket cup to upper reflector by engaging screw heads in keyhole slots and tighten until

snug. Screw heads must be fully engaged in slots in order for the lower trim to be installed (See

Figure 5).

8. Install lamp ensuring that correct type and wattage are used.

9. Attach safety chain to lower trim.

10. Install lower trim by aligning retention tabs with springs located in upper reflector. Push lower trim

into upper reflector ensuring that it is fully engaged.

WALLWASH TRIM ORIENTATION

Follow steps 1-10 from NEW INSTALLATION FOR SQ TRIM

11. Install lower trim by aligning retention tabs with springs located in upper reflector. The short side

of the trim must be aligned with the wallwash kicker (Figure 6). Push lower trim into upper reflector

ensuring that it is fully engaged.

CJ5200040 Rev. B

2/10 1 of 1

INSTALLATION INSTRUCTIONS

SQ and SQW trim

Figure 5

Figure 1 Figure 2

Figure 3

Retention

screw

Figure 4

Spring clips (4)

Wallwash

kicker

Align short

side with

kicker

Orient toward wall

Figure 6

1. Electric current can cause painful

shock or serious injury unless

handled properly. For you safety,

always remember the following:

• Turn off the supply power.

• Ground the fixture to avoid potential

electrical shocks.

• Do not handle an energized fixture or

energize any fixture with wet hands,

when standing on a wet or damp

surface, or in water

2. Specific safety information

concerning lamps:

• Match wattage of fixture and lamp

exactly.

• Do not remove or insert lamp when

power is on.

• Do not scratch glass or subject lamp

to undue pressure as either may cause

lamp breakage.

• Protect operating lamp from sources

of moisture.

• If lamp is marked it contains

mercury. Follow disposal laws. See:

www.lamprecycle.org

SAVE THESE INSTRUCTIONS 1

Summary of Contents

Page 1 - SAVE THESE INSTRUCTIONS

Upon receipt, thoroughly inspect for any freight damage which should be brought to the attention of the delivery carrier. Compare the catalog descript

Related models: SQ trim

Comments to this Manuals

No comments

Gotham SQW trim User Manual

Browse online or download User Manual for Lighting Gotham SQW trim. Gotham SQW trim User Manual

Summary of Contents

Related models: SQ trim

Comments to this Manuals

Related products and manuals for Lighting Gotham SQW trim