Gotham PDRG Trim Semi-Recessed Glass User Manual download pdf

IMPORTANT SAFETY INFORMATION

For Your Protection, Read Carefully

WARNING - Risk of fire. Do not install insu-

lation within 3 inches of fixture sides or

wiring compartment, nor above the fixture

in such a manner as to entrap heat.

1. Electric current can cause painful

shock or serious injury unless handled

properly. For your safety, always re-

member the following:

· Turn off the power supply.

· Ground the fixture to avoid poten-

tial electrical shocks.

· Do not handle an energized fixture

or energize any fixture with wet

hands, when standing on a wet or

damp surface, or in water.

· Double check all electrical connections

to be sure they are tight and correct.

2. Specific safety information concern-

ing lamps:

· Match wattage of fixture and lamp

exactly.

· Do not remove or insert lamp when

power is on.

· Do not scratch glass or subject lamp

to undue pressure as either may

cause lamp breakage.

· Protect operating lamp from sources

of moisture.

· If lamp is marked it contains mercury.

Follow disposal laws. See:

www.lamprecycle.org.

Upon receipt, thoroughly inspect for any

freight damage which should be brought

to the attention of the delivery carrier.

Compare the catalog description listed on

the packing slip with the label on the

carton to ensure that you have received

the correct merchandise.

INSTALLATION INSTRUCTIONS

PDRG Trim

Semi-Recessed Glass

New Installation

1. Slide both trim mounting brackets under lanced up tabs on the mounting frame

(Figure 1). Brackets may be secured to the mounting frame by screws or rivets

(supplied by others). NOTE: REMOVE AND DISCARD FRICTION CLIPS FROM

MOUNTING FRAME IF PRESENT.

2. Remove upper trim from glass by loosening two screws and disengaging them

from key hole slots ( Figure 2).

3. For HID and Incandescent products: Loosen two screws attaching socket

spring to socket cup. Grip socket and pull down, locating socket in lowest

possible position in the socket cup (Figure 3). Re-tighten screws. Attach

socket cup to the top of upper trim by aligning spring in socket cup with slots

in trim. For Compact Fluorescent products: Attach socket cup to top of upper

trim by aligning spring clip with alignment mark on upper trim (Figure 4). Slide

socket cup onto upper trim and turn until spring locks into place.

4. Push upper trim with socket cup attached through mounting frame opening

and align keyhole slots with screws in trim mounting brackets. Rotate upper

trim to engage in slots and tighten screws until trim flange is snug to ceiling

(DO NOT OVER-TORQUE) (Figure 5).

5. Install glass reflector to upper trim by lining up key hole slots with screws

located on bottom of upper trim (Figure 2). Rotate glass reflector to engage in

slots and tighten until screw heads are snug (DO NOT OVER-TORQUE).Tighten

safety screw until snug (Figure 2).

6. Install lamp. (Ensure that correct lamp type and wattage are used).

TRAHCGNITOOHSELBUORT

nimelborpehtetacol,noitidnocdoognimeesyehtfI.eludomni-emarfropmalehtotegamadelbis

ivynarofkcehC

.snoitcaevitcerrocdnasesuacelbissopfotsilgniwollofeht

motpmySesuaCelbissoPnoitcAevitcerroC

OTSLIAFPMAL

THGIL

dezigrenetonerutxifehtgnideeftiucriC·

noitcennocelud

omrotiucricnirorregniriW·

pmalytluaF·

tuptuotsallabroeniL·

tsallabytluaF·

wolooterutarepmettneibmA·

.dezig

renesitiucrictahterusneotesufrorekaerbtiucrickcehC·

erasnoitcennoctahterusneotxobecilpserutxifenimaxE·

.tcerroc

ylbareferp,pmalrehtonaetutitsbusdnapmalytluafehtevomeR·

lanigiroehtecalper,sthgilpmalehtfI.thg

ilotnwonksitahteno

.enowenahtiw

.egatlovtiucricnepokcehC.erutxiftaegatlovenilkcehC·

.ytiunitnoctiucrickc

ehC·

.snoitidnoclatnemnorivnegnitsixetsniagagnitartsallabkcehC·

TUOSEOGPMAL

GNITHGILRETFA

pmalytluaF· naht

rehtarmotpmyssihttibihxelliwpmalayllanoisaccO·

.pmalwenaetutitsbuS.thgilotgniliafylpmis

NOSELCYCPMAL

FFO

DNA

erutxifotesolcootsinoitalusnI·

hgihootegattawpmaL·

wolegatlovtuptuotsallaB·

)"3tsaelta(eludomdnuoramo

rfnoitalusnievomeR·

.gnisuohnideificepsegattawpmalllatsnI·

.egatlovtiucricnepokcehC.erutxifehttaegatlov

enilkcehC·

Figure 1

Figure 4

Figure 3

Figure 2

Part No. CJ520718

Rev. D 11/09

SAVE THESE INSTRUCTIONS

Trim Mounting

Bracket

Screw in Lowest

Socket Position

Align Socket Clip

with "V" Locator Mark

on Refector Shoulder

Trim Screw Heads

Shown in theProper

Slot Position

Figure 5

Ceiling

Insert Screws Into

Trim Slots and Tighten

Secure Locking Screw

After Trim Screws are

Secured and Tightened

SAVE THESE INSTRUCTIONS 1

Summary of Contents

Page 1 - SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY INFORMATIONFor Your Protection, Read CarefullyWARNING - Risk of fire. Do not install insu-lation within 3 inches of fixture sides orw

Comments to this Manuals

No comments

Gotham PDRG Trim Semi-Recessed Glass User Manual

Browse online or download User Manual for Lighting Gotham PDRG Trim Semi-Recessed Glass. Gotham PDRG Trim Semi-Recessed Glass User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Lighting Gotham PDRG Trim Semi-Recessed Glass